Chapter 2
Installation and Configuration
2-18
ni.com
Figure 2-4 shows the RT Series PXI target,
PXI-8101
, configured to
automatically obtain an IP address from a DHCP server, as indicated in
the
IP Settings
section of the figure. The NI PXI-8102 would appear
similar in MAX.
Figure 2-4.
Configuring RT Target Network Settings
6.
Expand the PXI controller view in the
Remote Systems
branch and
select
Software
.
7.
Click the
Add/Remove Software
button in the toolbar to launch the
LabVIEW Real-Time Software Wizard.
8.
Install the LabVIEW Real-Time software and device drivers that you
require on the RT target. Refer to the NI Web site at
ni.com/info
and
enter the info code
etspc
for the latest information about supported
software.
After installation of the software the controller will automatically reboot
and you will now be able to program it using LabVIEW Real-Time.
Note
Refer to the
RT Getting Started Guide
available on your host computer for more
information about setting up your RT target.
