National Instruments PCMCIA Serias, Начало работы

Страница: 19 / 62

Chapter 2 Installation and Verification
PCMCIA Serial for Windows 98/95 2-2 © National Instruments Corporation
3. Click on the Install button.
4. When prompted, insert the NI Serial Software for Windows 95/98 and
Windows NT (Setup Disk), and click on the Next button to proceed.
The software installation wizard begins with the screen shown in
Figure 2-2.
Figure 2-2. NI Serial Setup Screen
The setup wizard guides you through the necessary steps to install the
NI Serial software. You can go back and change values where
appropriate by clicking on the
Back button. You can exit the setup
where appropriate by clicking on the Cancel button.
5. If you need to install your hardware, or if this is your first time to install
the NI Serial software for Windows 98/95, skip to the next section,
Install the PCMCIA Serial Hardware . Otherwise, continue to Step 6.
6. If your hardware is already installed, restart Windows 98/95.
Windows 98/95 should automatically detect your hardware and
display one or more
New Hardware Found dialog boxes.
If no New Hardware Found dialog box appears, refer to the section
Forcing Windows to Detect the Serial Hardware in Appendix D,
Troubleshooting and Common Questions .