NI-FBUS Installation Guide for Windows
8
ni.com
3.
Slide the FBUS-HSE/H1 LD to the desired position along the DIN rail.
After the FBUS-HSE/H1 LD is in position, lock it to the DIN rail by
pushing the rail clip to the locked position, as shown in Figure 5.
4.
Connect the RJ-45 Ethernet port of the FBUS-HSE/H1 LD to an
Ethernet hub using a standard Category 5 Ethernet cable.
Note
Do
not
use a cable longer than 100 m. If you are using a 10 Mbps Ethernet,
National Instruments recommends using a Category 5 shielded twisted-pair Ethernet
cable.
5.
Figure 7 shows the power, H1, and Ethernet connectors on the
FBUS-HSE/H1 LD.
Figure 7.
Connectors on the FBUS-HSE/H1 LD
6.
Use the Fieldbus cable with 9-pin female D-sub connector to connect
the H1 ports of FBUS-HSE/H1 LD to a Fieldbus network.
1
H1 Port 1
2
H1 Port 2
3
Power
4
Ethernet
1
2
3
4
Содержание PCMCIA-FBUS/2
Страница 1: ...PCMCIA FBUS 2...
