National Instruments PC-DIO-24, Руководство пользователя

Страница: 40 / 75

Register-Level Programming Chapter 4
PC-DIO-24 User Manual 4-10 © National Instruments Corporation
The control word written to the CNFG Register to configure port B for output in mode 1 is
shown as follows. Notice that port B does not have extra input or output lines from port C.
1 X X X X 1 0 X
7 6 5 4 3 2 1 0
During a mode 1 data write transfer, the status of the handshaking lines and interrupt signals can
be obtained by reading port C. Notice that the bit definitions are different for a write and a read
transfer.
The following are the port C status-word bit definitions for output (port A and port B).
7 6 5 4 3 2 1 0
OBFA* INTEA I/O I/O INTRA INTEB OBFB* INTRB
Bit Name Description
7 OBFA* Output Buffer Full for Port A—Low indicates that the CPU has
written data to port A.
6 INTEA Interrupt Enable Bit for Port A—If this bit is high, interrupts are
enabled from the 82C55A for port A. Controlled by bit set/reset of
PC6.
5–4 I/O Input/Output—Extra I/O status line when port A is in mode 1
output.
3 INTRA Interrupt Request Status for Port A—When INTEA is high and
OBFA* is high, this bit is high, indicating that an interrupt request
is asserted.
2 INTEB Interrupt Enable Bit for Port B—If this bit is high, interrupts are
enabled from the 82C55A for port B. Controlled by bit set/reset of
PC2.
1 OBFB* Output Buffer Full for Port B—Low indicates that the CPU has
written data out to port B.
0 INTRB Interrupt Request Status for Port B—When INTEB is high and
OBFB* is high, this bit is high, indicating that an interrupt request
is asserted.