National Instruments NI TB-2631B, Руководство по установке

Страница: 7 / 8

© National Instruments Corporation 7 NI TB-2631B Installation Instructions
4. Install the Terminal Block
To connect the NI TB-2631B terminal block to the NI PXI-2530B front panel, complete the following
steps (the NI PXI-2530B should already be installed in a PXI chassis):
1. Plug the NI TB-2631B on to the front connector of the NI PXI-2530B as shown in Figure 3.
2. Tighten the top and bottom chassis screws on the back of the terminal block rear panel to hold it
securely in place.
Figure 3. Installing the NI TB-2631B Terminal Block
Compliance and Certifications
Safety
This product meets the requirements of the following standards of safety for electrical equipment for
measurement, control, and laboratory use:
• IEC 61010-1, EN 61010-1
• UL 61010-1, CSA 61010-1
Note
For UL and other safety certifications, refer to the product label or the Online Product
Certification section.
1 Chassis screw 2 Front connector 3 NI PXI-2530B 4 NI TB-2631B
1
2
3
4
NI PXI-2531B
128-Channel
Reed Rela
y
Multiplex
er / Matr
ix
NI
TB-2631B
4 X 32 Matr
ix
Ter
minal Bloc
k