National Instruments NI sbRIO-9627, Руководство по началу работы

Страница: 8 / 13

1. Right-click your system and select Web Configuration .
The NI Web-Based Configuration and Monitoring utility opens in your default browser
and is where you set the password. If you have not installed Microsoft Silverlight,
NI Web-based Configuration & Monitoring prompts you to do so.
2. Enter a unique name for your system in the Hostname field.
3. Click the Security Configuration icon.
4. Click
Login
.
5. In the Login dialog box, enter the username
admin
and leave the password field blank.
6. Click
OK
.
7. Click Change Password .
8. Enter and re-enter a new password.
9. Click
OK .
10. Click Save .
11. Click OK to confirm you are changing the password.
Caution
NI cannot recover lost system passwords. If you forget the password,
you must contact NI and reformat the controller.
Installing Software on the sbRIO-9627
Complete the following steps to install software on the sbRIO-9627.
1. In MAX, expand your system under Remote Systems.
2. Right-click
Software .
3. Select Add/Remove Software to launch the LabVIEW Real-Time Software Wizard.
Tip
You must log in if you set a system password.
4. Select the recommended software set for your LabVIEW and NI CompactRIO Device
Drivers versions.
5. Click Next .
6. Select
NI Scan Engine
from the software add-ons.
Select any additional software to install. If you plan on using the sbRIO-9627 with the
LabVIEW FPGA Module, you can click Next .
Tip
You can use this wizard at anytime to install additional software.
7. Click Next .
8. Verify that the summary of software to install is correct.
9. Click
Next to start the installation.
10. Click Finish when the installation is complete.
NI sbRIO-9627 Getting Started Guide | © National Instruments | 7