©
National Instruments Corporation
3
NI PXIe-8133 Installation Guide
Figure 2.
NI PXIe-8133 Controller Installed in a PXI Express Chassis
How to Remove the Controller from the PXI Express Chassis
The NI PXIe-8133 controller is designed for easy handling. To remove
the unit from the PXI Express chassis, complete the following steps.
1.
Power off the chassis.
2.
Unscrew the 4 bracket-retaining screws in the front panel.
3.
Press the injector/ejector handle down.
4.
Slide the unit out of the chassis.
What If the NI PXIe-8133 Does Not Boot?
Several problems can cause a controller not to boot. Here are some things
to look for and possible solutions.
Things to Notice
•
Which LEDs come on? The
PWROK/FAULT
LED should stay lit
green. The
Drive
LED should blink during boot as the disk is
accessed.
•
What appears on the display? Does it hang at some particular point
(BIOS, Operating System, and so on)? If nothing appears on the
screen, try a different monitor. Does your monitor work with a
different PC? If it hangs, note the last screen output that you saw for
reference when consulting National Instruments technical support.
1
NI PXIe-1082 Chassis
2
NI PXIe-8133 Controller
3
Injector/Ejector Rail
1
3
2
