background image

INSTALLATION GUIDE

NI PXIe-8133

This document contains information about installing your NI PXIe-8133 
controller in a PXI Express chassis. For complete configuration and 
troubleshooting information (including information about BIOS setup, 
adding RAM, and so on), see the 

NI PXIe-8133 User Manual

. The manual 

is in PDF format on the documentation CD included with your controller 
and on the National Instruments Web site, 

ni.com/manuals

.

Installing the NI PXIe-8133

This section contains general installation instructions for the 
NI PXIe-8133. Consult your PXI Express chassis user manual for specific 
instructions and warnings.

1.

Plug in your chassis before installing the NI PXIe-8133. The power 
cord grounds the chassis and protects it from electrical damage while 
you install the module.

Caution

To protect both yourself and the chassis from electrical hazards, leave the chassis 

powered off until you finish installing the NI PXIe-8133 module.

2.

Remove any panels blocking access to the system controller slot 
(Slot 1) in the chassis.

3.

Touch the metal part of the chassis case to discharge any static 
electricity that might be on your clothes or body.

4.

Remove the protective plastic covers from the four bracket-retaining 
screws as shown in Figure 1.

5.

Make sure the injector/ejector handle is in its downward position. 
Align the NI PXIe-8133 with the card guides on the top and bottom 
of the system controller slot.

Содержание NI PXIe-8133

Страница 1: ...ions and warnings 1 Plug in your chassis before installing the NI PXIe 8133 The power cord grounds the chassis and protects it from electrical damage while you install the module Caution To protect both yourself and the chassis from electrical hazards leave the chassis powered off until you finish installing the NI PXIe 8133 module 2 Remove any panels blocking access to the system controller slot ...

Страница 2: ...cure the NI PXIe 8133 to the chassis 9 Check the installation 10 Connect the keyboard and mouse to the USB connectors If you are using a PS 2 keyboard and a PS 2 mouse a Y splitter adapter is available to connect both to a single USB connector National Instruments offers a Y splitter adapter cable part number 778713 02 available through the online catalog at ni com products 11 Connect the DVI moni...

Страница 3: ...is What If the NI PXIe 8133 Does Not Boot Several problems can cause a controller not to boot Here are some things to look for and possible solutions Things to Notice Which LEDs come on The PWROK FAULT LED should stay lit green The Drive LED should blink during boot as the disk is accessed What appears on the display Does it hang at some particular point BIOS Operating System and so on If nothing ...

Страница 4: ...module is firmly seated in the chassis Remove all other modules from the chassis Remove any nonessential cables or devices Try the controller in a different chassis Try a similar controller in this same chassis Clear the CMOS Refer to the System CMOS section of the NI PXIe 8133 User Manual Recover the hard drive on the controller Refer to the Hard Drive Recovery section of the NI PXIe 8133 User Ma...

Отзывы: