National Instruments NI PXIe-7975R, Руководство по началу работы

Страница: 8 / 16

Installing the NI FlexRIO FPGA Module
Note
You must install the software before you install the hardware.
1. Power off and unplug the PXI Express chassis. Refer to your chassis manual to install or
configure the chassis.
2. Identify a supported PXI Express slot in the chassis. The figure below shows the symbols
that indicate the slot types in a PXI Express chassis.
Figure 3. Symbols for PXI Express/PXI Express HybridSlots
NI PXIe-1062Q
1 2 3 4 5
1. PXI Express System Controller Slot
2. PXI Peripheral Slot
3. PXI Express Hybrid Peripheral Slot 4. PXI Express System Timing Slot
5. PXI Express Peripheral Slot
Refer to the chassis documentation for specifications.
3. Remove the filler panel of an unused PXI Express slot.
4. Touch any metal part of the chassis to discharge any static electricity. Place the PXI
Express module edges into the module guides at the top and bottom of the chassis, and
slide the module into the chassis until the module is fully inserted, as shown in the figure
below.
NI PXIe-7975R FPGA Module Getting Started Guide | © National Instruments | 7