NI Switches Getting Started Guide
12
ni.com
Procedure 2: Cable the Controller to the SCXI Switch
If you are using an SCXI-1000/1001 or PXI-1010 chassis, complete the
following steps:
1.
Power off and unplug the SCXI chassis. Follow proper ESD
precautions to ensure you are grounded before installing the hardware.
2.
Set the chassis address switches to OFF. In Figure 5, all switches are
shown in the OFF position.
Note
Older chassis use jumpers inside the front panel, instead of chassis address
switches. Older chassis also differ in fuses and AC power selection. Refer to the chassis
documentation for more information.
3.
Confirm the correct power settings (100, 120, 220, or 240 VAC).
4.
Connect the power cord.
Figure 5.
Chassis Preparation
1
Chassis Address Switches
2
Chassis Power Switch
3
Power Settings
4
Power Cord Connector
Back
Front
SCXI
120V
ac
~
®
5
4
3
2
1
PO
WER
RESET
ADDRESS
1
2
3
4
RESET
ADDRESS
ON
5
4
3
2
1
