Table 1.
SAFE MODE Switch States
State
Description
ON
Essential services required for updating its configuration and installing software
launch when the cRIO-9024 boots. Place this switch in the ON position if the
software on the controller is corrupted or reformat the drive on the cRIO-9024.
OFF The embedded LabVIEW Real-Time engine launches when the cRIO-9024 boots.
Keep this switch in the OFF position during normal operation.
Note
Even if the switch is in the OFF position, the cRIO-9024 automatically boots
into safe mode if there is no software installed.
CONSOLE OUT Switch
The following table describes the ON and OFF states of the CONSOLE OUT switch.
Table 2.
CONSOLE OUT Switch States
State
Description
ON
Enables console out. You can read the IP address and firmware version of the
cRIO-9024 using a serial-port terminal program. Connect the cRIO-9024 serial port
to a computer using a null-modem cable and configure the serial-port terminal
program with the following settings:
•
9,600 bits per second
•
Eight data bits
•
No parity
•
One stop bit
•
No flow control
The serial-port terminal program displays the IP address and firmware version of the
cRIO-9024, and alerts you when you connect an unsupported USB device to the
cRIO-9024.
OFF Disables console out. Keep this switch in the OFF position during normal operation.
IP RESET Switch
The following table describes the ON and OFF states of the IP RESET switch.
10
|
ni.com
|
NI cRIO-9024 User Manual and Specifications
