National Instruments NI 9512 C Series, Начало работы, Страница: 35 / 41

34
|
ni.com | Getting Started with NI 9512 Modules and AKD Servo Drives
21. In the eth0 (Primary) section click More Settings and change Packet Detection to
Polling . Leave the Polling Interval at 1 ms.
When you have completed these steps the Network Settings tab will look similar to
Figure 24.
Figure 24. Network Settings Ta b
22. Click Save .
23. Close MAX.
24. Continue with Step 2: Create a Project in Scan Interface Mode .
Adding the EtherCAT Master Device to the La b VIEW
Project
If you are using the NI 9144 chassis, complete the following steps to add the EtherCAT master
device and detect the C Series modules.
1. In the LabVIEW Project Explorer window, right-click the master controller and select
New»Targets and Devices .
2. In the Add Targets and Devices dialog window shown in Figure 25, select Existing target
or device and expand the category EtherCAT Master Device to auto-discover the EtherCAT
port on the master controller. An EtherCAT master device and modules can be added
manually at any time.