![background image](http://html1.mh-extra.com/html/national-instruments/ni-9512-c-series/ni-9512-c-series_getting-started_3401836033.webp)
32
|
ni.com | Getting Started with NI 9512 Modules and AKD Servo Drives
Note
Do not plug in or turn on any power to the system until after you complete
Step 8: Connect the Drive Communication
.
3.
Connect the secondary port of your EtherCAT Master directly to the IN port (top port) on
the NI 9144 chassis using a standard Category 5 Ethernet cable. If you are using the
NI cRIO-9074 as your EtherCAT Master, the secondary port is top port (LAN PORT #2).
If you are using a PXI system, you must add a PXI-8231/8232 network card for the
secondary port. You may expand the deterministic Ethernet network by connecting an
additional NI 9144 chassis or other slave devices to the OUT port (bottom port) on the first
NI 9144 chassis.
Figure 23.
Connecting the NI 9144 Chassis to Network
4.
Install the NI 9512 module in slot 1, 2, 3, or 4 of the NI 9144 chassis.
5.
If using the NI 9144 chassis with a PXI master controller, disable
Legacy USB Support
in
the host PC BIOS, if it is enabled.
6.
Continue with
Step 2: Connect NI 9512 to AKD Drive Cable to the C Series Module
Software Installation and Configuration with the NI 9144
Complete the following steps to configure the controller and install software on it.
1.
Launch Measurement & Automation Explorer (MAX) on the development computer by
clicking the MAX icon on the desktop (
), or by selecting
Start»All
Programs»National Instruments»Measurement & Automation
.
2.
Expand the
Remote Systems
tree.
3.
Select the controller under
Remote Systems
in the
Configuration
pane.
Note
If you do not see the controller, you may need to disable the firewall on the
development computer. Go to
ni.com/info
and enter
RIOMAXTroubleshoot
for more information.
4.
Verify that the
Serial Number
in the
Identification
section matches the serial number on
the device.
5.
If you do not want to format the disk on the controller, eliminating all installed software and
files, power on the controller and skip to step 15.
Addition
a
l
NI 9144 Ch
ass
i
s
/
S
l
a
ve Device
s
NI 9144 Exp
a
n
s
ion Ch
ass
i
s
NI M
as
ter Controller
Ho
s
t
Comp
u
ter
Ethernet
S
econd
a
ry
Prim
a
ry
IN
OUT
EtherCAT
Содержание NI 9512 C Series
Страница 1: ...NI 9512...