This product is intended for use in industrial locations. However, harmful interference may
occur in some installations, when the product is connected to a peripheral device or test object,
or if the product is used in residential or commercial areas. To minimize interference with
radio and television reception and prevent unacceptable performance degradation, install and
use this product in strict accordance with the instructions in the product documentation.
Furthermore, any changes or modifications to the product not expressly approved by National
Instruments could void your authority to operate it under your local regulatory rules.
Special Conditions for Marine Applications
Some products are Lloyd’s Register (LR) Type Approved for marine (shipboard) applications.
To verify Lloyd’s Register certification for a product, visit
the LR certificate, or look for the Lloyd’s Register mark on the product.
Caution
In order to meet the EMC requirements for marine applications, install the
product in a shielded enclosure with shielded and/or filtered power and input/output
ports. In addition, take precautions when designing, selecting, and installing
measurement probes and cables to ensure that the desired EMC performance is
attained.
What You Need to Install the NI 9157/9159
•
NI 9157/9159 reconfigurable embedded chassis with integrated MXI-Express (x1)
•
One of the following MXI-Express (x1) host systems:
–
PXI system with MXI-Express device installed
–
PC with MXI-Express PCI or PCIe device installed
–
NI Industrial Controller
Note
The NI 9157/9159 requires a host system with a PCI Express clock that
complies with the
PCI Express Specification
. The NI 9157/9159 may not be
compatible with systems using noncompliant clocks, particularly clocks with
peak frequencies higher than 100 MHz. For more information about PCI
Express clock compatibility with the NI 9157/9159, go to
and enter
the Info Code
915xclock
.
•
C Series I/O modules
•
MXI-Express (x1) cable(s) up to 7 m long
•
DIN rail mount kit (for DIN rail mounting only)
•
Panel mount kit (for panel mounting only)
•
Three M4 or number 8 panhead screws (for mounting the chassis without one of the listed
mounting kits)
•
Number 2 Phillips screwdriver
NI 9157/9159 User Manual and Specifications
|
© National Instruments
|
3
