Getting Started with NI SMD-7620/7621 and NI 73xx
|
© National Instruments
|
31
Step 4: Test the Motor In MAX
You will now move the motor using the NI motion controller and MAX. Select the
1-D
Interactive
panel in the Configuration tree and change the settings to match those shown in
Figure 23. Change the axis if you are not using Axis 1.
Figure 23.
1-D Interactive Panel Settings
13. Click
Start
. Your motor should rotate 1 revolution at 60 rpm.
14. Finalize your motion system setup by connecting and configuring additional I/O such as
limits as required by your application .
•
If using the UMI-7764, use the available screw-terminal connections on the same axis
terminal block as the integrated steppers connections.
•
If using the UMI-7772/7774, use the DB9M, DB15M, and DB25M pigtail cables.
