![background image](http://html.mh-extra.com/html/national-instruments/ni-17xx/ni-17xx_getting-started_709630008.webp)
Getting Started with the NI 17xx
8
ni.com
Connect to the Development Computer
The NI Smart Camera can connect to the development computer
directly or through a network using an Ethernet cable. The smart
camera provides automatic MDI/MDI-X correction, so you can use
either a standard Ethernet cable or a crossover Ethernet cable
to connect to the development computer. If the development
computer is configured on a network, you must configure the smart
camera on the same network subnet as the development computer
to connect through the network.
Caution
To prevent data loss and to maintain the integrity
of your Ethernet installation, do not use a cable longer
than 100 m. National Instruments recommends using a
shielded twisted pair Ethernet cable for maximum signal
integrity.
Firewall Configuration
If your firewall is controlled remotely or you are unsure about
configuring the firewall, contact your network administrator. Refer
to Appendix B,
Troubleshooting
, of the
NI 17xx Smart Camera
User Manual
to troubleshoot network configuration issues.
Direct Connection
To connect the NI Smart Camera directly to the development
computer, refer to Figure 3 and complete the following steps.