IMAQ D100 Cable Installation Guide
2
©
National Instruments Corporation
Installation
As shown in Figure 1, insert the 100-pin SCSI-type connector end of the
IMAQ D100 cable into the external 100-pin SCSI-type receptacle of your
IMAQ device, ensuring correct polarity. Tighten the thumbscrews as
necessary.
Insert the camera connector end of the IMAQ D100 cable into the
receptacle of your camera, ensuring correct polarity. Tighten the
thumbscrews as necessary.
Triggering
If you plan to connect external trigger signals to your IMAQ device, you
can use either the IMAQ D2504 cable or your own trigger interface cable.
If building your own cable, see Figure 2 for pin-out information. For more
information on the D2504 cable, see the IMAQ 2504 Cable Installation
Guide.
Insert the trigger interface cable into the trigger connector of the D100
cable, ensuring correct polarity. Tighten the thumbscrews as necessary.
