![background image](http://html1.mh-extra.com/html/national-instruments/gpib-usb-series/gpib-usb-series_hardware-manual_3531097020.webp)
Chapter 1
GPIB Hardware
©
National Instruments
1-13
GPIB-ENET/100
GPIB-ENET/100 Installation
Follow these steps and refer to Figure 1-8 to install the GPIB-ENET/100:
1.
Connect one end of your Ethernet cable to your GPIB-ENET/100.
Connect the other end of the Ethernet cable to your Ethernet network.
2.
Connect one end of the power cord to the power supply. Screw the
power connector on the other end of the power supply onto the power
jack of the GPIB-ENET/100.
3.
Plug the other end of the power cord into an AC outlet.
Figure 1-8.
Installing the GPIB-ENET/100
4.
Refer to the
Baseplate Identification Label
on the base of the
GPIB-ENET/100 and make a note of the serial number, Ethernet
address, and default hostname. You will need this information when
you run some of the utilities.
5.
Contact your network administrator to determine whether your
network supports DHCP or if you need to manually perform the
Ethernet configuration to set up the network parameters. If your
1
Front Panel LEDs
2
GPIB Cable
3
Power Cord
4
Power Supply
5
Ethernet Connector
6
Power Connector
7
Ethernet Cable
8
To Ethernet Network
N
AT
IO
NA
L
IN
ST
RU
ME
NT
S
8
7
4
3
2
6
5
1