National Instruments GPIB-SCSI-A, Начало работы

Страница: 34 / 35

© National Instruments Corporation I-1 GPIB-SCSI-A for Solaris
Index
C
cables
connecting GPIB cable, 2-9
connecting SCSI cable, 2-9
GPIB cable types, 1-1
caution
hazardous voltages, A-1
operating at wrong voltage, 2-1
powering off the system before connecting
cables, 2-9
too many sets of terminating resistors on
SCSI bus, 2-6
common questions, A-1
configuring
GPIB-SCSI-A, 2-1
operating mode, 2-5
power-on primary GPIB address, 2-2
SCSI ID, 2-2
software, 2-11
connecting cables, 2-9
connecting GPIB-SCSI-A to SPARC system
connecting cables, 2-9
powering on the GPIB-SCSI-A, 2-10
powering on your system, 2-10
shutting down the system, 2-9
connecting more than 14 devices, 1-2
conventions used in the manual,
vi
customer education, C-1
D
DIP switch SW1 settings, 2-2
DIP switch SW2 settings, 2-5
E
electrical characteristics, B-1
environmental characteristics, B-1
error checking, A-2
G
getting started, 1-1
GPIB cables
disconnecting before running ibtsta, A-2
single shielded or double shielded, 1-1
GPIB communication, A-3
GPIB-SCSI-A
configuring, 2-1
factory configuration, 2-2
methods for connecting to SPARC
system, 2-8
overview, 1-2
POWER LED, 2-10
READY LED, 2-10
rear panel (figure), 2-1
troubleshooting, A-1
I
ibconf
configuring software, 2-11
ibfind, A-3
ibic
using, 4-1, A-2
ibtsta
failure, A-2
verifying installation, A-2
installing
NI-488.2, 2-10
GS.book Page 1 Tuesday, June 12, 2001 2:17 PM