Hardware and Software Configuration
Appendix C
GPIB-PCII/IIA for Graphics
C-20
© National Instruments Corp.
Logic Ground Connected to Shield Ground (Default)
Logic Ground Disconnected from Shield Ground
W1
W1
Figure C-9. Ground Configuration Jumper Settings
Be sure to record the jumper setting on the GPIB-PCII/IIA Hardware and
Software Configuration Form in Appendix E, Customer Communication.
Step 2. Run the IBDIAG Diagnostic Program
If you have changed any hardware configuration settings, you must run the
diagnostic program,
IBDIAG
, again. For instructions on running
IBDIAG
,
refer to Appendix C, Interactive Software Installation.
Step 3. Configure the Software
If you have changed any hardware configuration settings, you must make
appropriate changes to the NI-488.2 handler. To do so, you must run the
configuration program,
IBCONF
or
WIBCONF
, and edit the board parameters
(such as the base I/O address or interrupt line) that you have changed.
If you are using the NI-488.2 software for Windows, skip to Configuring the
Software for Windows, later in this appendix. If you are using the NI-488.2
software for MS-DOS, proceed to the next section, Configuring the Software for
MS-DOS.
