©
National Instruments Corporation
1-1
1
Introduction
This chapter lists what you need to get started and optional equipment
you can order, and briefly describes the GPIB-ENET/100 hardware and
NI-488.2 for HP-UX.
What You Need to Get Started
Before you install your GPIB-ENET/100 hardware and NI-488.2 for
HP-UX, make sure you have all of the following items:
❑
HP-UX 9.01or higher installed on your computer
❑
TCP/IP protocol installed on your computer
❑
GPIB-ENET/100, which is included in your hardware kit
❑
GPIB-ENET/100 power supply, which is included in your hardware kit
❑
One of the following power cords, which is included in your
hardware kit:
–
U.S. standard power cord
–
Switzerland power cord
–
Australian power cord
–
Universal European power cord
–
North American power cord
–
U.K. power cord
❑
3.5 in.
NI-488.2 for HP-UX and GPIB-ENET/100, Version 1.4
distribution disk
❑
One of the following Category 5 twisted-pair network cables,
which you can purchase from National Instruments:
–
Straight-through cable for connecting the GPIB-ENET/100 to
a network hub
–
Cross-over cable for connecting the GPIB-ENET/100 directly
to a computer’s network interface card (NIC)