©
National Instruments Corporation
A-1
A
PWR/RDY LED Signaling
This appendix describes how to interpret the
PWR/RDY
LED error codes.
PWR/RDY LED Overview
The
PWR/RDY
LED has several purposes on the GPIB-ENET/100.
When you first power on the unit, the
PWR/RDY
LED alternates rapidly
between red and yellow while it completes its power-on self-tests and
acquires network parameters. When the tests complete successfully and
the IP address is assigned from either nonvolatile memory or the network,
the
PWR/RDY
LED remains steady yellow, indicating that the unit is
ready to operate.
The
PWR/RDY
LED also alternates rapidly between red and yellow
while the device is in network configuration mode. At other times, the
PWR/RDY
LED blinks slowly in a recognizable pattern to alert you of
internal errors. Use this appendix to interpret and record the pattern that
the
PWR/RDY
LED flashes, and then contact National Instruments.
Note
By recording the
PWR/RDY
LED status messages before calling National
Instruments, you can save yourself time, and the Product Support Department can
answer your questions more accurately and efficiently. Do not switch off power to
your GPIB-ENET/100 before recording the flashing
PWR/RDY
LED pattern.
PWR/RDY
LED signaling can report up to 81 different errors. The errors
are numbered from 11 to 99 and are reported through sequences of
PWR/RDY
LED flashes.
Note
There is no zero in any error message. This means that error message numbers 0–10,
20, 30, 40, 50, 60, 70, 80, and 90 are not possible.