National Instruments GPIB-1284CT, Начало работы, Страница: 11 / 33

Chapter 1 Introduction
© National Instruments Corporation 1-3 GPIB-1284CT for Windows
it is in pass-through mode; all parallel port activity from the host computer
is routed to the pass-through parallel port. The NI-488.2 driver switches
the GPIB-1284CT into GPIB mode when a device or board is put online.
For information about pass-through printing in Windows, refer to the
Use
Pass-Through Printing section in Chapter 3, Install and Configure
the Software .
The parallel-to-GPIB conversion circuitry is implemented in a
field-programmable gate array, which you can reconfigure with the
ctupdate
utility. For more information, refer to Appendix A, Updating
Your Firmware . As parallel port standards evolve, National Instruments
provides updates to keep your hardware and software up-to-date.
Top Panel
Figure 1-1 shows the GPIB-1284CT top panel.
Figure 1-1. GPIB-1284CT Top Panel
PO
WER
READ
Y
PASS THR
OUGH
TALK LISTEN
Pass Through Connector
Computer
Connector
GPIB
Connector