National Instruments Corporation
E-1
DAQCard E Series User Manual
Power-Management Modes
Appendix
E
This appendix describes the power-management modes of the
DAQCard E Series cards.
•
Normal Mode—This is the normal operating mode of the
DAQCard E Series cards in which all the circuits are fully
functional. See the specifications for each DAQCard in
Appendix A for power consumption in the normal mode. The
DAQCard is automatically configured for normal mode upon
insertion.
•
Power-Down Mode—In this mode, the digital circuitry is powered
on and is functional. The analog input circuit is powered down by
setting the PWRDOWN bit in the PCMCIA Card Configuration and
Status Register. You can set the PWRDOWN bit by using the
DAQPOWER
utility that is shipped with NI-DAQ. Use
DAQPOWER-D
to power down and
DAQPOWER-U
to power up the
DAQCard E Series cards. Power-down mode is specified to draw
less than 100 mA from the 5 V supply (500 mW). See the power
consumption specifications in Appendix A for exact values. The
DAQCard is automatically configured for normal mode upon
insertion.
Note:
National Instruments strongly recommends that you power down your
DAQCard when you are not actively using it. Doing so will greatly extend
your computer’s battery life.
Table E-1 shows the effects of different power-management modes on
the DAQCard E Series circuits.
This document was created with FrameMaker 4.0.4
