Figure 7.
One Edge of the DIN Rail Inserted in a Clip
3
2
1
1. DIN rail clip
2. DIN rail
3. DIN rail spring
3.
Press down firmly on the chassis to compress the spring until the clip locks in place on
the DIN rail.
Caution
Ensure that the chassis does not contain any I/O modules before you
remove it.
Mounting the Chassis on a Desktop
You can use the NI 9901 desktop mounting kit to mount the chassis on a desktop. Install the
adapter bracket using two M3 × 20 screws. National Instruments provides the adapter bracket
and screws with the desktop mounting kit. Refer to the NI 9901 documentation for more
information about mounting the chassis on a desktop.
Installing C Series I/O Modules in the Chassis
Note
Before you install a C Series I/O module in the chassis, ensure that no
I/O-side power is connected to the module. If the system is in a nonhazardous
location, the chassis power can be on when you install modules.
Complete the following steps to install a C Series I/O module in the chassis.
1.
Align the module with a slot in the chassis, as shown in the following figure. The module
slots are labeled 1 to 8, left to right.
8
|
ni.com
|
Maintaining NI CMS-9024 Hardware for an NI InsightCM System