Table 2.
Additional Resources for System Dimensions and Cabling Clearance
Consideration
Resource
Where can I find more information about dimensions
of the system, included detailed dimensional
drawings?
Visit
ni.com/dimensions
.
Where can I find more information about the
minimum cabling clearance for C Series modules with
other connector types?
Visit
ni.com/info
and enter the
Info Code
rdcrioconn
.
Mounting the Chassis Directly on a Flat Surface Using
the Mounting Holes
Complete the following steps to mount the chassis directly on a flat, rigid surface using the
mounting holes in the chassis. National Instruments recommends that you mount the chassis in
this manner for environments with high shock and vibration.
1.
Use the dimensions provided in this document to prepare the surface for mounting the
chassis.
2.
Align the chassis on the surface.
3.
Fasten the chassis to the surface using two M4 or number 10 panhead screws appropriate
for the surface, as shown in the following figure. Screws must be longer than
19 mm (0.75 in.) to pass all the way through the chassis. National Instruments does not
provide these screws with the chassis.
Figure 5.
Mounting the cRIO-9114 Directly on a Flat Surface
1
2
3
4
5
6
7
8
Caution
Ensure that the chassis does not contain any I/O modules before you
remove it.
Mounting the Chassis the NI Panel Mounting Kit
Complete the following steps to use the NI panel mounting kit (part number 779558-01) to
mount the chassis on a flat surface.
6
|
ni.com
|
Maintaining NI CMS-9024 Hardware for an NI InsightCM System