Maintenance
Installation (Figure 4)
Before installing new liners, check the wheel housing and its corners for wear.
1.
Put the pressure screw (1) for the top liner (2) in place.
2.
Move the top liner (2) through the opening of the wheel housing and turn it around the motor shaft (6) into the upper part of the housing.
3.
Place the side liners (3 & 4) in the housing, so the bolts can be pushed through the holes in the side of the housing.
4.
Put the screws (5) on the bolts and tighten them slightly.
5.
Place the side liners (3 & 4) inside the housing so the liner sticks out at the bottom of the housing approximately 3/32” (2 mm).
6. Fasten the side liners with the screws.
7.
Fix the pressure screw (1) s the edges of the top liner are sitting on the upper edges of the slide liners.
8.
Mount the remaining components (A) of the blast wheel.
9.
Set the control cage for operation.
13
FIG. 4
Содержание 3395
Страница 1: ...Read Manual Before Servicing Machine 402966 Rev F 3395 SHOT BLASTER SERVICE MANUAL...
Страница 2: ......
Страница 26: ......
Страница 27: ......