National Flooring Equipent 8000 series, Руководство по обслуживанию, Страница: 10 / 36

Maintenance
DUAL SLIDE PLATE REMOVAL
1. Lower the slide plate to the floor and place a wood block under the assembly.
2. Remove the front cylinder by taking the 1/2” bolt out of the bottom and removing the
hitch clips and pin from the top of the cylinder.
3. Remove the E-clips from the pin at the bottom of the internal cylinder, then remove
the pin.
4. Remove the pin from the top of the internal cylinder and then remove the cylinder
from the machine.
5. Loosen the pinch bolt from the lower right side of the frame.
6. Remove the lock nut from securing bolts at the top of the slide plate.
7. Remove the socket head screws at the top of the dual slide from both sides of the
assembly.
8. Install 3/8-16x5” bolts into the holes the socket head screws were removed from.
Once installed the bolts should be used as lifting handles.
9. Lift the frame out of the machine, use team lift or forklift (Caution: very heavy).
LEAK MAINTENANCE
Most fittings on this machine are O-ring style.
1. Disconnect machine from power.
2. If a leak is detected, tighten fitting with the proper wrench size. Do not over-tighten.
Note: Most fittings on this machine are O-ring style. Over-tightening could damage
to O-rings.
HYDRAULICS
Check Fluid Level
1. Remove filler plug (Figure 1).
2. Oil should be visible 1” below hole.
3. Reinsert plug.
Change Fluid
1. Let hydraulic fluid cool before maintenance. Disconnect machine from battery.
2. Drain fluid by removing the drain plug from side of tank (Figure 1). This unit con-
tains 6 gallons (22.7 liters) of fluid. Ensure the container size is adequate to catch
fluid.
3. Replace drain plug.
4. Remove filler plug (Figure 1).
5. Add oil into filler plug hole. Total tank capacity is 6 gallons (22.7 liters). Due to a cer-
tain amount of retained oil, the oil change refill amount is 5.5 gallons (20.8 liters).
NOTE: Adding more than this amount could cause the oil to overflow from the vent
tube.
10
FIG. 1
Filler Plug
Drain Plug
CAUTION:
LET ENGINE COOL BEFORE ANY MAINTENANCE. FAILURE TO DO
SO COULD CAUSE SERIOUS BODILY INJURY.