National Comfort Products Comfort Pack CPE U Series, Руководство по установке

Страница: 35 / 36

Installation Guide for Comfort Pack (CPE) Units
ENGINEERING SPECIFICATION GUIDE
1. Product Name
National Comfort Products – Comfort Pack
2. Manufacturer
National Comfort Products
539 Dunksferry Road, Bensalem, PA 19020
Phone: (800) 523-7138:
Fax: (215) 639-1674
Email:
sales@NationalComfortProducts.com
Website: www.NationalComfortProducts.com
3. Product Description
Comfort Pack is a SPVU heating and cooling unit designed
for the multi-family industry. It is self-contained heating and
cooling thru the wall packaged unit available with gas or
electric heat. Thru the wall operation saves money and time
with simple and easy installation, and removes the need for
long line sets or electrical runs.
Models
CPG – Gas Heat (Natural or LP) w/ Electric Cooling
CPE – Electric Heat w/ Electric Cooling
Capacities natural gas is not available we offer heating
packages of 5, 7.5, 10 and 15 KW.
Materials
Cabinet to be constructed of Pre-Painted Galvanized Steel
Color – Neutral tone finish of Tan
Voltage
Factory wired for 230 Volts 1 Phase 60 Hertz and can be
field adjusted for 208 Volts. Operating voltages are from
197 to 253 Volts. All CPE ratings are based at 230 Volts.
Indoor Air Flow
Top Supply (outlet), Bottom Return (inlet) (Approved for
front/open return if local codes apply)(Optional return boot
available for top return designs)
Filter
Factory filter easily accessed by thumb screw mounted
panel w/ filter retainer rod.
Slide Out Chassis
Serviceable slide out cooling section with Coremax
refrigeration service ports. 5 Speed DC blower motor.
Evaporator and Condenser Coils shall be fabricated of
raised lanced aluminum fins mechanically bonded to
seamless rifled copper tubes.
Secondary Drain
Secondary condensate drain with trap piped to outdoor
section of unit for drainage thru exterior weep holes
providing extra protection and indication of primary drain
blockages.
Slide Out Furnace (Gas)
Serviceable slide out gas furnace assembly with stainless
steel heat exchanger.
Sequencing Control (Electric)
Two stage heat sequencing triac control board.
4. Technical Data Limitations
All installations should factor a proper building heat loss/
gain, along with appropriate duct sizing, gas mains and
riser sizing, and electrical supply wiring to be figured by a
professional engineer familiar with local and national codes.
5. Standard Controls & Components
Equipped to operate with a standard (1H/1C or 2H/1C) low
voltage thermostat. Factory mounted junction box provided
for field wiring. 16x25x1 washable air filter. Gas units
equipped with dual LED diagnostic light. ¾” o.d. primary
drain connection with flexible tubing provided.
6. Install
Recommended installation with CPWS wall sleeve for clean
finish and future service accessibility. A 29” wide by 29”
deep open area must be provided unobstructed in front of
the access panels for chassis and furnace service removal.
7. Sales
Comfort Pack is available thru a variety of wholesalers.
Contact the factory to help locate a nearby distributor for
price and availability.
8. Warranty
5 Year warranty on all parts, 5 year warranty on compressor
and 10 year warranty of the heat exchanger (gas only). 90
day labor warranty.
9. Service
The Comfort Pack is equipped with a slide out cooling
chassis and a slide out furnace for simple maintenance and
service. All standard maintenance instructions can be found
in the installation guides.
10. Technical Support
Factory technical assistance is available to help with any
concerns or situations regarding the Comfort Pack.