National Communications
Page 13
PROGRAMMING NOTES
The procedure for User Parameter Programming is described on pages
14 - 15.
You must temporarily connect a standard analogue telephone to the
SLS1
Line Out port, as Program Changes are made by using ‘touch
tone’ keys
The following notes provide important information about the programming
procedure :
1) To enter PROGRAMMING MODE you must turn OFF POWER to
your unit and then switch POWER ON AGAIN.
2) Using ANY TELEPHONE connected to the Line Out port of
SLS1
PRESS # within 30 SECONDS.
3) You will hear 3 short ‘beeps’ to confirm you are in programming
mode.
4) Individual Parameter Programming Entries are carried out by
pressing further keys on the attached telephone
5) Your unit will generate 1 short ‘beep’ to confirm acceptance of
command.
6) Your unit will generate 1 long ‘beep’ to advise of an entry error.
7) If 1 long ‘beep’ is detected, your command should be repeated.
8) You can exit PROGRAMMING MODE at any time by hanging up.
