Page 10
National Communications
ANNOUNCEMENT - INSTALLATION
Where an existing ANSWERING MACHINE is being replaced
1.
Disconnect Power to the existing Answering Machine.
2.
Remove the Telephone Cable which is connected to the existing
Answering Machine, from the socket where it connects to it.
3.
Connect the Telephone Cable (removed above) to the LINE
IN port located at the rear of DMS.
Please Note : If the Answering Machine is still required to record
incoming messages, then you should connect it to the LINE OUT
port located at the rear of DMS.
4.
Power Connection
A 12VAC/1A power adaptor is supplied with your unit. This must be
connected to an electrical power outlet, which is switched ON.
5.
Announcement Message Volume Check
Turn On the Announcement facility by pressing the Button located
on the top face of DMS.
Place a call to the telephone system by dialing your normal telephone
n u m b e r. D M S w i l l t h e n A N S W E R y o u r c a l l a n d p l a y y o u r
Announcement Message before hanging up (note - DMS will take
approx 15 seconds before hanging up, as it is programmed by default
to ring an Answering Machine that may be connected to the Line Out
port.
If the volume is too high or too low, you can adjust the volume to a
suitable level using the volume pot located on the rear of
DMS
.
Turning the POT clockwise will increase the volume.
Note - Changing the volume will also change the volume of the
ON HOLD MESSAGE as well, so you will need to set a volume
which is suitable for both Message Applications.
DMS should be connected in parallel with Line 1
