SM57 Rev. 4.10
DA80 Series DigiVOX™ Digital Intercom Manual
2.3.7
Mechanical Installation
The DA80 Digital Intercom can be installed in any attitude, using the DA80-IKC
Installation kit (refer to Section 2.5 for details).
For proper installation, refer to
Mounting Diagram
(DA80\
xxx
\920-0, where
xxx
represents the model of the unit under consideration) and the following steps:
a)
Before proceeding to install the DA80 into the aircraft, secure the black metal
faceplate to the DA80 with one mounting screw (countersink holes facing out).
b)
Remove the desired label from the sheet provided and using minimum pressure
align the label on the black faceplate. When the alignment is correct remove the
faceplate from the unit.
c)
Lay the faceplate on a flat surface and press label firmly in place ensuring there
are no air bubbles.
d)
Referencing the drill template, drill required mounting holes in the aircraft panel
and insert the DA80 from behind the panel.
e)
Attach the black metal faceplate (with label attached) from the front, with the
countersunk holes facing out. Secure with the mounting screws provided.
Note
: Ensure that the aircraft panel is tightly ‘sandwiched’ between the DA80
and faceplate.
f)
Rotate the shaft of the VOX potentiometer fully ccw. Align the white marker on
the knob (part of 40-21-VOX2) to the LIVE position on the faceplate label. Using
a 0.05" Allen key, tighten the knob onto the potentiometer shaft.
g)
Using a 0.05" Allen key, loosely attach the knob (part of 40-21-ICS2) onto the
ICS VOL potentiometer shaft. Rotate the shaft of the ICS VOL potentiometer
fully ccw. Using the Allen key, loosen the knob on the potentiometer shaft and
align the white marker on the knob (part of 40-21-ICS2) to the MIN. position on
the faceplate label. Using the Allen key, tighten the knob onto the potentiometer
shaft.
Oct 13, 2004
Page 2-5
ENG-FORM: 805-0104.DOT
PROPRIETARY AND CONFIDENTIAL TO NORTHERN AIRBORNE TECHNOLOGY LTD.
