SIREN R3 USER MANUAL
P5
Programming R3 Heads to R3 Receiver:
1.
Press and hold Power and Volume buttons together for 3
seconds until a bleep is heard.
2.
LED 1 will light and stay lit. Sounding an R3 alarm will pair
it to that channel. Pairing is confirmed when the LED on the
Receiver flashes. Short press the Power button to light the
second LED. R3 alarms can be sequentially paired in this way
through channels one to four.
3.
Once you have paired all the R3 heads you require press
and hold Volume and Power buttons for 3 seconds to exit
programming, signified by a double bleep.
4.
The fifth channel can be paired with up to 32 different
R3 alarms. To pair R3 heads with the fifth channel enter
programming mode by pressing and holding Power and Volume
buttons together for 3 seconds until a bleep is heard.
5.
Short press the Volume button, and the fifth LED on the
Receiver will light and stay lit. When an R3 alarm sounds and is
successfully paired the LED flashes. Short press Volume button
and the LED lights and stays lit, ready to pair with further R3
heads on the same channel.
Once you have paired all the R3 heads you require press
and hold Volume and Power buttons for 3 seconds to exit
programming, signified by a double bleep.
Erasing programmed R3 heads from the R3 Receiver:
1.
Press Power and Volume Buttons together, without releasing.
After 3 seconds the first LED will light and a bleep will be heard.
2.
Continue to keep both buttons depressed together for a
further 3 seconds, until three consecutive bleeps are heard
and the LED turns off. This signifies any existing pairings with
R3 alarms have been erased. Note individual heads cannot be
selected and erased from the R3 receiver, all pairings have to
be erased.
2020 SIREN R3 USER MANUAL 25.02.20.indd 5
13/07/2020 08:41