NASdeluxe NDL-2400R-R, Руководство пользователя

Страница: 77 / 94

NASdeluxe NDL-2400R iSCSI/NAS System - Manual
www.NASdeluxe.com
Page 77
Chapter 8: Troubleshooting
Forgot My Password
If you forget your password, you can reset the unit to use the default password.
To do this, press the reset button on the front panel after system is booted, and
NDL-2400R will be reset. WAN IP address will become
192.168.1.100
and admin
password will be
admin
.
Forgot My Network IP Address
If you forget your network IP address and have no physical access to the system,
you can find out the IP address by either looking directly onto the NDL-2400R’s
LCD panel, or by using the setup wizard to retrieve the IP of your NDL-2400R.
1. Start the Setup Wizard, and it will automatically detect all NASdeluxe IP
storage products on your network.
2.
You should be able to find the IP address of the NDL-2400R which you
have forgotten in the Device Discovery screen.
Resetting NAS IP Address and Admin Password
In case you changed the NDL-2400R IP address and then forgot it, or forgot the
administration password, follow the steps below to reset to default settings:
1. Power on the NDL-2400R till system ready and press the Reset button
while buzzer with long beeping approximately 3-5 seconds. (The reset
button is right below power button)
2. This resets the NDL-2400R to its default IP address and password settings.
Default IP:
192.168.1.100
for WAN and
192.168.2.100
for LAN
Default admin password:
admin
Jumbo Frame support:
disabled
HTTP Port: 80, HTTPs:443
Can't Map a Network Drive in Windows XP
You may have problems mapping a network drive under the following conditions:
1. The network folder is currently mapped using a different user name and
password. To connect using a different user name and password, first
disconnect any existing mappings to this network share.
2. The mapped network drive could not be created because the following
error has occurred: Multiple connections to a server or shared
resource by the same user, using more than one user name, are
not allowed. Disconnect all previous connections to the server or shared
resource and try again.
To check out existing network connections, type
net use
under the DOS prompt.
You may refer the URL below for more network mapping information.
http://www.NASdeluxe.com