6
CARE AND MAINTENANCE
Cleaning
Normal soil on the surface of the simulator can be removed with mild soap and warm water.
Use Nasco Cleaner (LF09919U) to remove stubborn stains from simulator. Simply apply
Nasco Cleaner to the soiled area and wipe clean with cloth or paper towels.
Storage
Before storage, be sure to remove the catheter from the urethra. The lubricant can dry out and
act as a mild adhesive if the catheter is left in place. This results in damage to the simulator
when removed.
Do not store simulator for extended periods of time with water in the unit. Before returning
simulator to case, drain as much liquid as possible from the bladder.
1.
Close the slide clamp on the fluid administration set.
(See Figure 8.)
2.
Remove the catheter.
3.
Stand simulator on its plastic base and elevate placing both tubes in a water-safe con-
tainer.
(See Figure 9.)
(Water-safe container not included.)
4.
Open the slide clamp on the fluid administration set, and the pinch clamp on the drain
tube and allow system to drain.
(See Figure 9.)
Any residual water inside the simulator
should drain out through the quick-disconnect fitting and drain tube.
5.
Dry all surfaces to prevent mildew formation while stored in the case.
Caution
Solvents or corrosive materials will damage the simulator. Never place simulator on any kind of
printed paper or plastic. These materials will transfer indelible stains. Ballpoint pens will also
make indelible stains.
Figure 8
Figure 9
6
CARE AND MAINTENANCE
Cleaning
Normal soil on the surface of the simulator can be removed with mild soap and warm water.
Use Nasco Cleaner (LF09919U) to remove stubborn stains from simulator. Simply apply
Nasco Cleaner to the soiled area and wipe clean with cloth or paper towels.
Storage
Before storage, be sure to remove the catheter from the urethra. The lubricant can dry out and
act as a mild adhesive if the catheter is left in place. This results in damage to the simulator
when removed.
Do not store simulator for extended periods of time with water in the unit. Before returning
simulator to case, drain as much liquid as possible from the bladder.
1.
Close the slide clamp on the fluid administration set.
(See Figure 8.)
2.
Remove the catheter.
3.
Stand simulator on its plastic base and elevate placing both tubes in a water-safe con-
tainer.
(See Figure 9.)
(Water-safe container not included.)
4.
Open the slide clamp on the fluid administration set, and the pinch clamp on the drain
tube and allow system to drain.
(See Figure 9.)
Any residual water inside the simulator
should drain out through the quick-disconnect fitting and drain tube.
5.
Dry all surfaces to prevent mildew formation while stored in the case.
Caution
Solvents or corrosive materials will damage the simulator. Never place simulator on any kind of
printed paper or plastic. These materials will transfer indelible stains. Ballpoint pens will also
make indelible stains.
Figure 8
Figure 9
HC190001INM19.indd 11-12
2/22/19 3:10 PM
