English
19
Technical specification
Cordless impact wrench:
Model
ASR 18-S ASR 18 HT-S
Voltage
18.0 V 18.0 V
Idle speed:
0–2 000 rpm
0–1 700 rpm
Number of strokes:
0–3 000 rpm
0–2 000 rpm
Tightening moment max.:
400 Nm
800 Nm
Scope of application:
Metric screws
M12–M18
M12–M24
Wood screws - dia. max.:
8 mm
Drilling - dia. max.:
into metal
8 mm
into wood
18 mm
Spindle
½“ square
½“ square
Weight w/o accumulators
1.25 kg
2.4 kg
Charger:
Model
AN-UNI C
Input voltage
110–240 V
Frequency
50–60 Hz
Power input
80–100 W
Output voltage
16.6–20.7 V
Charging current
4 A
Charge time
ca 25–45 min*
Weight
0.7 kg
Class of protection
II /
Accumulator:
Model
AP 18 LE AP 18 LP
Voltage
18.0 V 18.0 V
Cell type
Li-Ion
Li-Ion
Capacity
1.5 Ah 3.0 Ah
Temperature of charging
0–45 °C
0–45 °C
Charge time
ca 25 min
ca 45 min
Monitor. of the temp.of charging
thermistor
thermistor
Weight
0.52 kg 0.78 kg
* Depending on model and capacity of the accumulator to be charged!
Description:
1 ...........Accumulator
2 ...........Accumulator clamp
3 ...........Switching–in push button with speed control
4 ...........Reversing switch
5 ...........Spindle - ½“ square
6 ...........Workplace LED lighting
7 ...........Accumulator state indication panel
8a .........Indication switch
8b .........Accumulator state indicator
9 ...........LED signal lights
10 .........Charger
11 .........Vent holes of the accumulator air cooling system
Zobrazené anebo popsané příslušenství nemusí patřit do objemu
dodávky.
Scope of use
The cordless impact nut runners are specified for screwing and the
cordless impact nut runner ASR 18-S even for drilling into wood,
metal and plastics.
Double insulation
To ensure maximum safety of the user our tools are designed and
built to satisfy applicable European standards (EN standards). Tools
with double insulation are marked by the international symbol of
a double square. These tools must not be grounded and a two-wire
cable is sufficient to supply them with power. Tools are shielded in
accordance with EN 55014.
Charging battery pack instructions
1. Make sure that circuit voltage is the same as than shown on
the charger specification plate. Connect the charger (10) to
power source. Red LED signal light should light up (9). This
indicates the charger is ready to being charging. If the red LID
light is not on, check connection to the power source. If the
power source is OK, transport the charger into the authorized
service workshop!
2. Position the accumulator/battery pack (1) into the charger as
far as the stop, see the Fig.
3. The red light will go out and the green light begins to blink,
indicating that the battery pack is receiving a “Fast Charge”.
4. After approximately 25–45 minutes (depending on battery
pack type) the battery pack is fully charged. The green light
will become steady.
5. Press the accumulator clamps (2) on both sides and by pull the ac-
cumulator out of the charger. If you do not want to charge another
accumulator, disconnect the charger from the power source.
