Operation manual for Acme series V4.2
- 24 -
If the floating voltage is not set correctly (too low or not amend according to
temperature), the battery system will in an insufficient charge state for a long
period of time. When the electricity is cut, the battery may not be able to work
because the active material is sulfated and the capacity is decreased.
2.2
Over Charge
Please do not neglect the performance of rectify to transfer floating charge to
equalization charge. If the rectify cannot transfer charge modes because of its
wrong performance or no adjustment, the battery system is always in an
equalization charge state. Thus may cause serious problems for battery, such as
water loss, life decrease, heat out of control, deformation, etc.
2.3
Too low or too high temperature
We have mentioned that too low temperature will affect the capacity of battery.
While too high temperature will also cause problems, such as water loss, life
decrease, heat out of control, deformation, etc.
2.4
Too low end voltage
The end voltage is also an important parameter for battery. The battery shall stop
discharge when reach a certain voltage (The normal end voltage is 10.5V, in some
special causes, is 9.6V). If the end voltage is too low, it will be difficult to
recharge the battery and decrease the charge efficiency, thus reduce the life of
battery.
2.5
Charge the battery immediately after discharge.
If the battery is put aside without charge for a long time (2 hours above) after
discharge, it will affect the capacity and life of the battery. Because some large
size PbSO
4
will create in the negative which are difficult to transfer to active Pb.
