Napoleon ZCVF36, Инструкция по установке и эксплуатации

Страница: 12 / 16

12
W415-0527 / A / 04.14.11
* Note: In either application it is necessary to remove the variable speed switch from the wiring har-
ness and install into an electrical switch box as per electrical codes.
WITH THERMAL SWITCH BRACKET
A. Remove the hearth pads and the
blower access cover.
B. Install the blower using the
optional blower installation
instructions.
C. Pull the black and white thermal
disc wires through the 7/8”
bushing in the blower access
cover.
D. Cut the white wire as close to the
connector as possible.
E. Cut the red wire as close to the
plug as possible.
F. Using a box connector, connect
supply wire through the junction
cover plate located on the right
side of the fi rebox enclosure.
G. Connect the red and white wires
to the power supply. Attach the
ground to the ground screw on
the junction plate cover.
H. Replace the blower access cover.
I. Attach the black & white wires to the back of the thermal
switch and install at the rear of the fi rebox using the
thermal switch support bracket as illustrated.
J. Replace the hearth pads.
WITHOUT THERMAL SWITCH BRACKET
A. Remove the hearth pads and blower access cover.
B. Install the blower using the optional blower installation
instructions.
C. Cut the red wire as close to the plug as possible.
D. Cut the black wire as close to the fl ag connection as
possible.
E. Using a box connector, connect supply wire though the
junction cover plate located on the right side of the fi rebox
enclosure.
F. Attach the ground to the ground screw on the junction
plate cover.
G. Replace the blower access cover plate and hearth pads.
GROUND
S
C
R
E
W
1
2
3
4
5
1. Hearth Pads
2. Blower Access Cover
3. Thermal Switch Support Bracket
4. 7/8” Bushing
5. Junction Plate
6. Thermal Switch Bracket
6
WHITE
RED
BLACK
BLOWER
VARIABLE
SPEED
SWITCH
THERMAL DISC
THERMAL DISC
WHITE
RED
BLACK
BLOWER
VARIABLE
SPEED
SWITCH
*
*