1. Lower the unit into the opening. Feed the wiring harness through the opening on the left hand side. Feed the gas flex
connector and regulator down through the opening on the right hand side.
2. Remove the electrical box cover. Install the electrical box into the opening (fasteners not included). Feed the three
white wires coming from the grill head into the hole in the back of the electrical box. Ensure the snap bushing is inserted
into the hole. Feed the black electrical cord from the inside out through the same bushing. If you are connecting the
power directly to the GFI outlet, disconnect the black electrical cord and use the same terminals on the GFI to connect the
power. Attach the white wires to the transformer output. The two wires marked T2 to one output, and the one wire
marked T1, to the other output. Re-install the electrical box cover. Plug the power cord into a suitable GFI protected
outdoor outlet.
3. For natural gas units, mount the regulator to the cabinet. Connect the gas supply to the inlet side of the regulator. For
propane units, connect the gas supply to the end of the flexible connector.
4. If using the optional trim kit, install the rear and side trim pieces using a dab of silicone.
5. Leak test the entire installation before operating the unit.
N570-0046
OPTIONAL
TRIM KIT
N370-0362
ELECTRICAL BOX
