regulator from the cylinder (according to the directions supplied with the regulator) when the barbecue is
not in use.
The Barbecue must be used in a well ventilated area. Do not obstruct the flow of combustion air to the
burner when the barbecue is in use. ONLY USE THIS BARBECUE OUTDOORS.
BEFORE USE CHECK FOR LEAKS
Never check for leaks with a naked flame, always use a soapy water solution
TO CHECK FOR LEAKS
Make 2-3 fluid ounces of leak detecting solution by mixing 1 part dish soap with 3 parts water.
Ensure the control valve is “OFF”.
Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the connections are secure
then turn ON the gas.
Brush the soapy solution onto the hose and all joints. If bubbles appear you have a leak, which must be
rectified before use.
Retest after fixing the fault
Turn OFF the gas at the cylinder after testing.
If leakage is detected and cannot be rectified. Do not attempt to cure leakage but consult your gas dealer.
Lighting Instructions for barbecue
1.
Open the hood of the barbecue before attempting to light the burners.
2.
Turn all the control knobs clockwise to “OFF” position.
3.
Connect the regulator to the gas bottle. Turn the gas supply “ON” at the regulator. Check with the use of
soapy water for any gas leakage between the bottle and the regulator.
4.
Push down the left hand control knob and turn it anti-clockwise to the “Full rate” position, A click will be
heard this will be the piezo ignition device repeat this 4 or 5 times, this will light the burner. Observe if the
burner has lit. If not repeat this process.
5.
If the burner has not lit after retrying wait 5 minutes and repeat step 4.
6.
Adjust the heat by turning the knob to the High/Low position.
7.
If the burner does not light. Light the appliance with a match using the lighting hole in the side of the
appliance. Consult your gas dealer to rectify the ignition.
8.
To light the remaining burners in sequence from left to right, and repeat 4 above. The crosslighting channel
between the burners will light the burner adjacent to it. NEVER ATTEMPT TO LIGHT THE LEFT HAND
MIDDLE, CENTRE, RIGHT HAND MIDDLE or RIGHT HAND BURNER FIRST.
9.
To turn the barbecue ‘OFF’ turn the cylinder valve or regulator switch to the ‘OFF’ position and then turn
the control knob on the appliance clockwise to the ‘OFF’ position.
Warning:
If the burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder valve off.
Wait five minutes before attempting to relight with ignition sequence.
Lighting Instructions (Side burner)
1.
Open the lid of the side burner.
