Napoleon PRESTIGE V 450, Инструкция по эксплуатации

Страница: 12 / 42

12
www.napoleongrills.com
Troubleshooting
Problem Possible Causes Solution
Low heat / Low flame when
valve turned to high.
Improper lighting procedure.
Improper preheating.
Ensure lighting procedure is followed carefully. All gas
grill valves must be in the off position when the tank
valve is turned on. Turn tank on slowly to allow pressure
to equalize. See lighting instructions.
Preheat grill with both main burners on high for 10 to
15 minutes.
Excessive flare-ups/uneven
heat.
Sear plates installed
incorrectly.
Improper preheating.
Excessive grease and ash build
on sear plates and in drip pan.
Ensure sear plates are installed with the holes towards
the front and the slots on the bottom. See assembly
instructions.
Preheat grill with both main burners on high for 10 to
15 minutes.
Clean sear plates and drip pan regularly. Do not line pan
with aluminum foil. Refer to cleaning instructions.
Burners burn with yellow
flame, accompanied by the
smell of gas.
Possible spider web or other
debris.
Thoroughly clean burner by removing. See general
maintenance instructions.
i) Never throw water into the grill to control flare-ups.
ii) Do not attempt to operate the infrared burners in open air while raining.
iii) If you find standing water in your grill (because of exposure to rainfall, sprinklers, etc.), inspect the
ceramic for evidence of possible watersoaking. If the ceramic appears to be wet, remove the burner from the
grill. Turn it upside down to drain the excess water and bring indoors to dry thoroughly.
3. Impaired ventilation of hot air from the grill - For the burners to function properly, hot air must have a way
to escape the grill. If the hot air is not allowed to escape, the burners can become deprived of oxygen causing
them to back-flash. If this occurs repeatedly, the ceramic could crack. Never cover more than 75% of the cooking
surface with solid metal (i.e., griddle or large pan).
4. Incorrect cleaning - Do not clean the ceramic tile with a wire brush. If debris is collecting on your burner,
light the burner and operate on high for 5 minutes with the lid open, allowing debris to burn off.
REPLACEMENT SCREEN N565-0002