Napoleon Allure NEFL100FH, Руководство по обслуживанию

Страница: 12 / 30

W415-1698 / 12.20.16
12
EN
4.1.2 MOTOR TESTING
NO
NO
YES
YES
Replace the PCB
Refer to section 6.2 (Control
Board Replacement)
Replace the motor
Refer to section 6.1
(Motor Replacement)
Replace the wire harness
Refer to section 6.7 (Wire
Harness Replacement)
Unplug the appliance
(If hardwired, turn off circuit breaker)
Unplug the appliance
(If hardwired, turn off circuit breaker)
Plug in the appliance and press power
button on the control panel
(If hardwired, turn on circuit breaker)
Plug in the appliance and press
power button on the control panel
(If hardwired, turn on circuit breaker)
Set multimeter to read
AC voltage
Place positive probe on the MOTOR
terminal of the PCB (Figure 4)
Disconnect the wire on the
MOTOR terminal on the PCB
Reconnect the wire into the
MOTOR terminal on the PCB
Place negative probe on the AC-N / AC-N1
terminal of the PCB (Figure 5)
Is there a voltage reading
approximately 120V AC?
Follow the wire from the motor until
you reach the plastic connectors and
disconnect them (Figure 6)
Using the female wire connector coming from
the PCB, place positive probe into the terminal
with the orange wire and the negative probe
into the terminal with the purple wire (Figure 7)
Is the voltage reading
approximately 120V AC?
START HERE