TENT SETUP
TENT TAKE DOWN
Unzip travel cover and release Velcro ladder
straps. Undo the straps across the tent.
Disengage ladder and fully extend it from tent base so that it
is parallel to the ground.
Using the ladder, press downwards until ladder meets the
ground. The tent base should now be horizontal and the tent
fully upright. The ladder should be at a sixty degree angle
(approximately) to the ground.
Adjust ladder height using locking levers to
be at desired height. Once desired height is
in place, secure locking levers.
12
A)
To open the awnings, insert the hook end of the
gold metal rods into the grommet hole found on the
corners of each awning/window.
B)
Locate the fabric slits in the tent skirt and insert
the rod at a 45 degree angle until snug (approxi-
mately half an inch). Repeat for all eight rods.
16
13
15
14
17
18
19
20
21
22
23
When finished camping, hook the four black bungee cords into the
eight plastic rings inside the tent (two above window, two beside lower
part of window on both sides). Clip horizontally from window to
window to help pull sides in when folding the tent closed.
Remove all gold metal rods.
Fasten all corners of awning and rainfly.
Push ladder up to close tent. Retract ladder and secure Velcro strap.
Fasten the four Velcro straps on each side of the tent.
Zip cover on over tent.
Fasten the two long-looped straps on each side of the ladder.
60º
NOTE:
If rainfly is wet, open once at home to dry out.
