• Do not use candles, matches or open flames of any kind in or
near the tent
• Do not cook inside the tent
• Build campfires downwind and several meters away from the
tent. Be sure to fully extinguish fires before leaving a campsite
or before retiring for the night
• Exercise extreme caution when using fuel-powered lanterns or
heaters inside or around the tent. Use battery-operated
lanterns whenever possible
• Do not refuel lamps, heaters or stoves inside the tent
• Extinguish or turn off all lanterns before going to sleep
• Do not smoke inside the tent
• Do not store flammable liquids inside a tent
• NEVER run the vehicle engine when the tent is attached
• Do not install the tent when the temperature is below
0ºC/32ºF or when your vehicle is wet, it may cause damage
• Allow adequate ventilation inside the tent at all times
• Do not attempt to drive the vehicle with the tent attached
CAMPSITE SELECTION
• Select a smooth level campsite clear of rocks, branches and
other hard or sharp objects
• Park the vehicle in the chosen campsite. Turn off the engine
and apply the parking brake
TENT SETUP
1. Remove the tent from the tent bag and lay it flat on the ground
with the vehicle sleeve facing the cargo area of the vehicle.
At this point, do not stake the tent to the ground.
3. Insert one of the tent poles diagonally, corner-to-corner
through the pole sleeves in the roof of the tent. Repeat with
the other tent pole.
2016 Napier Outdoors
Rev. 02 01.11.16
2 of 8
2. Assemble the tent poles by unfolding each section.
CAUTION
5. Once the tent is standing, attach the plastic clips to the
tent poles.
4. Take either pole and insert the pin located on the corner of the
tent into the pole end. On the opposite end of the pole, insert
the pin into the end of the pole. Repeat with the other pole.
NOTE: The poles may get stuck in the pole sleeve. Do not force
the pole - gently lead it through the fabric sleeve.
