X
GEM-X255 Programming Instructions
L
NAPCO Security Systems
WI1092B 9/02
!
Page 52
KEYPAD CONFIGURATION MODE
This section will focus on configuring the GEM-RP1CAe2 and GEM-RP2ASe2 Keypads. If there is more than one keypad in the
system,
only Keypad No. 1 may be used for programming.
KEYPAD INSTALLATION
Each must be assigned an address number (1–15) and each requires its own configuration procedure (see CONFIGURING THE
KEYPADS, which follows, and DIRECT ADDRESS KEYPAD AREA OPTIONS). At least 1 keypad must be used; only 1 is required
for a single-area Commercial Burglary installation.
GEM-RP1CAe2
- is a 2-line combination fire/burglary/access keypad capable of supporting 4 EZM zones and a PGM output. A
GEM-RP1CAe2 is recommended for use as Keypad #1.
CONFIGURING THE KEYPADS
A total of up to 15 keypads may be connected to the panel.
Configuring the GEM-RP1CAe2 Keypad
Each GEM-RP1CAe2 keypad must be configured for (a) keypad tactile beep; (b) entry sounder; (c) keypad address; (d) compatibility
number; (e) EZM address; and (f) zone response.
To enter the GEM-RP1CAe2 Configuration Mode:
1. Move jumper JP5 (located at the upper-right corner of the control panel board) from Pins 1-2 (top two) to Pins
2-3 (bottom
two).
NOTE:
See Wiring Diagram on page 80.
2. After about 15 seconds, the display will read “
XX OUT OF SYSTEM
”, where XX indicates the keypad address.
3. Press
11123
A
and proceed as follows. (Repeat the following procedure
for all keypads.)
Keypad Tactile Beep
Upon entering the Keypad Configuration Mode, “
KEYPAD BEEP ON
” will be displayed,
indicating that the tactile beep, which sounds when any button is pressed, is on. To
turn off the tactile beep, press the
J
button (the
J
button will toggle the tactile
beep on and off).
Press the
A
button to continue or press the
C
button to exit.
Entry Sounder
To turn off the keypad sounder during entry time, press the
J
button (the
J
button
will toggle the tactile beep on and off). Press the
A
button to continue or
press the
C
button to exit.
Keypad Address
If more than one keypad is installed, each must be assigned a unique keypad
address (that is, no two keypads may be numbered alike):
!
keypads must be numbered consecutively (missing numbers are not permitted)
!
only Keypad No. 1 may be used for programming.
To assign the keypad number, proceed as follows:
1. Enter the assigned keypad number 01–15, then press the
J
button to save. A valid number will be acknowledged by a short
beep; an invalid number will be rejected by a long beep.
2. Press the
A
button to continue or press the
C
button to exit.
KEYPAD BEEP ON
ENTRY SOUNDER ON
KEYPAD ADDRESS 01
NORMAL
KEYPAD
CONFIGURE
R
COMPUTERIZED SECURITY SYSTEM
GEMINI
ARM
ED ST
ATU
S
SYSTEM ARMED
01/01/97 12:00AM
1 2
4
3
5 6
7 8 9 0
A
B
C
D
E
F
G
NEXT/YES
PRIOR/NO
AREA
# OF ZONES IN AREA 1
ENTER # ZONES X X
KEYPAD BEEP ON
Ke
yp
ad
Configura
tion Mode
: Conf
iguring the Key
p
ads
