1 Introduction
be provided with corresponding warning notices and instructions for safe use and safe operation. All warning
notices provided by Nanotec must be passed on directly to the end user.
1.4 Warranty and disclaimer
Nanotec assumes no liability for damages and malfunctions resulting from installation errors, failure to
observe this manual or improper repairs. The selection and use of Nanotec products is the responsibility of
the plant engineer or end user. Nanotec accepts no responsibility for the integration of the product in the end
system.
Our general terms and conditions at www.nanotec.com apply.
Customers of Nanotec Electronic US Inc. please refer to
.
NOTICE
Changes or modifications to the product are not permitted.
1.5 Target group and qualification
The product and this documentation are directed towards technically trained specialists staff such as:
■
Development engineers
■
Plant engineers
■
Installers/service personnel
■
Application engineers
Only specialists may install and commission the product. Specialist staff are persons who
■
have appropriate training and experience in work with motors and their control,
■
are familiar with and understand the content of this technical manual,
■
know the applicable regulations.
1.6 EU directives for product safety
The following EU directives were observed:
■
RoHS directive (2011/65/EU, 2015/863/EU)
■
EMC directive (2014/30/EU)
1.7 Used icons
All notices are in the same format. The degree of the hazard is divided into the following classes.
WARNING
!
The WARNING notice indicates a possibly dangerous situation.
Failure to observe the notice may result in severe or fatal injuries.
►
Describes how you can avoid the danger.
CAUTION
!
The CAUTION notice indicates a possibly dangerous situation.
Failure to observe the notice may result in moderately severe injuries.
►
Describes how you can avoid the dangerous situation.
Version: 1.2.0
4
