EZ-Tear Thermal Printer
Owner’s Manual
1.4 Installation
Mounting your printer
The Nanoptix EZTear printers have four 4.5mm mounting holes at the base that can be
used to mount the printer on a variety of surfaces. Please refer to the drawings in Figure
8 for proper hole spacing.
Note:
The Nanoptix EZTear printers must be mounted on surfaces with a flatness of less
than 0.63mm (.025") total deviation. If the mounting surface in your application does not
meet the above specification (ex. shop grade plywood), please contact Nanoptix for
options that will ensure the proper functioning of your EZTear printer.
1.5 Printer Controls
To reset Printer
Simply plug and unplug the printer to reset in the event of a fault condition. Once the
Printer is re-plugged, it will go through a startup routine and resets itself. The LED will
light up. Note: there should be paper loaded in the printer and the door should be
closed.
Power Connector
Figure 3: Resetting Printer
102136
July, 2005
4
