Motor User Manual
Motor Installation
Nanomotion Ltd.
16
Bonding the Driving Strip to the Stage
4.2
Bond the Ceramic Driving Strip to the stage surface according to the following
steps:
Clean the bonding area of the stage, using a suitable agent such as Acetone,
1.
IPA or Ethanol.
Remove the Acrylic adhesive Tape backing paper from the Ceramic Driving
2.
Strip.
Attach the Ceramic Driving Strip to the previously cleaned stage area (see Figure
1), making sure no air bubbles are trapped between the stage and the ceramic.
Figure 1: Bonding the Ceramic Driving Strip
Verify that there is a maximum gap of 0.5mm between the lower edge of the
3.
Ceramic Driving Strip and the motor mounting surface (refer to chapter
7) to
assure enough clearance for the motor tip.
Apply Epoxy adhesive on the center of the Ceramic Driving Strip surface,
4.
about 5 mm length (see Figure 1). For short strips up to 10mm, a single drop
can be applied on each end of the Ceramic Driving Strip (see Optional Epoxy
drop in Figure 1). The Epoxy must bond the strip to the slide. Recommended
adhesive: Araldite 2014-1 or compatible.
Allow the required time period for curing, according to the epoxy
5.
manufacturer’s specifications.
Epoxy strip of 5mm in the
center of the ceramic strip
Optional Epoxy drop on
the end of the ceramic
