18
·
5-pin shielded cable with a diameter not less than 0.3mm must be used for connection between light fixture and DMX/RDM console, or between light fixture and
light fixture. XLR plug/socket and the cable should be connected as picture above.
·
Pin1, Pin2, Pin3 for connecting DMX signal. Pin4, Pin5 has no connection.
▲NOTE: When connecting DMX, make sure the internal pin is not in contact with the inner case. The fixture can match the DMX512 (1990) control signal.
·
5-pin and 3-pin XLR plug/socket conversion
The fixture comes with 5-pin XLR plug/socket. lf a 3-pin XLR plug is used, please follow the instruction below.
②
DMX Terminator
ln DMX control mode, the DMX output of the last fixture should be connected with a DMX terminator (Not included). This prevents interference caused by DMX
signals in the transmitting process. The terminator is connected with a 120Ω(OHM) resistor across Pin 2 and Pin 3. (As shown below)
Three Pin
Pin 1:GND(SCREEN)
Pin 2:Signal(-)
Pin 3:)
Five Pin
Pin 1:GND(SCREEN)
Pin 2:Signal(-)
Pin 3:)
Pin 4:N/C
Pin 5:N/C
DMX Terminator Connection
Connect a 120Ω(OHM) resistor
across Pin 2 and Pin 3 in an
XLR plug and insert into the
DMX OUT socket on the last unit.
PIN 2 PIN 3
③
ADDRESS Setting.
④
Refer to the attached DMX reference guide and control the light via DMX/RDM console.
(For specific operation methods, please refer to the DMX/RDM console operation manual.)
Note: DMX reference guide
《
Evoke 1200B DMX REFERENCE GUIDE
》
please download it from www.nanlux.com.
120Ω
1
2
3
5
4
