7
1
3
2
120Ω
PIN 2
PIN 3
3. DMX Circuit
In DMX mode, make sure the last light is the only light with a cable connected to the DMX output. There is a
resistance about 120(OHM) between the second pin and third pin of this plug (as shown). Make sure this plug
can be installed into the output interface of the last fixture, this will help avoid noise and reflection phenomenon
caused by the DMX signal during the transmitting process.
4. DMX Channel Control
When using a DMX console to control the fixture, each one must be set to its own DMX address, to receive the
dimmer signal and response correctly. The fixture has a total of 5 channels, set the first fixture's DMX start address
to 001, 006 for the second one displays, 012 for the third one and so on.
